JrFreak Distinguished Mar 20, 2009 230 0 18,690 Jan 1, 2012 #1 I am putting this on my system and the X-bracket in the back is not tight... I have the screws tighened down pretty snug but the bracket still has slop in it... is this ok?
I am putting this on my system and the X-bracket in the back is not tight... I have the screws tighened down pretty snug but the bracket still has slop in it... is this ok?
Solution HostileDonut Jan 2, 2012 I am going to assume this is using the 2600k. If so, those are great temps. As long as your load temps are good too, you are good to go!
I am going to assume this is using the 2600k. If so, those are great temps. As long as your load temps are good too, you are good to go!
JrFreak Distinguished Mar 20, 2009 230 0 18,690 Jan 2, 2012 #2 I think I got it in OK. 25 deg C OK for a cpu idle temp? Upvote 0 Downvote
HostileDonut Splendid Aug 29, 2010 4,076 0 23,160 Jan 2, 2012 Solution #3 I am going to assume this is using the 2600k. If so, those are great temps. As long as your load temps are good too, you are good to go! Upvote 0 Downvote Solution
I am going to assume this is using the 2600k. If so, those are great temps. As long as your load temps are good too, you are good to go!
Motopsychojdn Illustrious Jan 26, 2010 11,749 3 41,960 Jan 2, 2012 #4 You can always make up a spacer to take up the slack on a bolt/screw Moto Upvote 0 Downvote
JrFreak Distinguished Mar 20, 2009 230 0 18,690 Jan 14, 2012 #6 Best answer selected by jrfreak. Upvote 0 Downvote