Hello,
I have read it's a good idea to have the same speed fans if you want to do a push/pull setup with the CM Hyper 212+.
I have an extra 120mm fan lying around that has a similar RPM to the 120mm exhaust fan I'm using in the back of my case. They both run at about 1K RPM each.
I was thinking about configuring these two fans in to a push/pull setup and then using the fan that came with the heatsink as the exhaust fan. That one runs at about 1850 RPM.
Does anyone know which configuration would perform better?
I have read it's a good idea to have the same speed fans if you want to do a push/pull setup with the CM Hyper 212+.
I have an extra 120mm fan lying around that has a similar RPM to the 120mm exhaust fan I'm using in the back of my case. They both run at about 1K RPM each.
I was thinking about configuring these two fans in to a push/pull setup and then using the fan that came with the heatsink as the exhaust fan. That one runs at about 1850 RPM.
Does anyone know which configuration would perform better?