DIFFERENT MEMORY SPEED IN CPU-Z
Last response: in Memory
Why should the CPU-Z report my memory's DRAM Frequency as 333.3? The JEDEC #1 is 333.3, and #2 is 400. But I don't understand this. The "Max Bandwidth" section says: PC2-6400 (400 MHz)
I had got a single stick of 2mB of RAM installed that should have been of 800 mhz. Is this the case? Because I had thought that 800 x 2mB would become 1600 mhz! Earlier I had 667 MHz.
Thanks
I had got a single stick of 2mB of RAM installed that should have been of 800 mhz. Is this the case? Because I had thought that 800 x 2mB would become 1600 mhz! Earlier I had 667 MHz.
Thanks
More about : memory speed cpu
Here is the info on the "Memory" tab:
--General---------
Type: DDR2
Size: 2048 MBytes
Channels #: Single
DC Mode: empty
NB Frequency: empty
----------------------------------
--Timings---------
DRAM Frequency: 333.3 MHz
FSB : DRAM: 4:5
CAS# Latency (CL): 5.0 clocks
RAS# to CAS# Delay (tRCD): 5 clocks
RAS# Precharge (tRP): 5 clocks
Cycle Time (tRAS): 15 clocks
Bank Cycle Time (tRC): 21 clocks
[The last four rows "Command Rate (CR)", "DRAM Idle Timer", "Total CAS# tRDRAM)", and "Row To Column (tRCD)", are empty.]
--General---------
Type: DDR2
Size: 2048 MBytes
Channels #: Single
DC Mode: empty
NB Frequency: empty
----------------------------------
--Timings---------
DRAM Frequency: 333.3 MHz
FSB : DRAM: 4:5
CAS# Latency (CL): 5.0 clocks
RAS# to CAS# Delay (tRCD): 5 clocks
RAS# Precharge (tRP): 5 clocks
Cycle Time (tRAS): 15 clocks
Bank Cycle Time (tRC): 21 clocks
[The last four rows "Command Rate (CR)", "DRAM Idle Timer", "Total CAS# tRDRAM)", and "Row To Column (tRCD)", are empty.]
Related ressources:
- ForumDifferent memory speed in BIOS and CPU-Z
- ForumTwin ddr3 memory showing different speeds in cpuz
- ForumDid I ruin my CPU? Different Core Speed in BIOS vs. CPU-Z
- ForumDifferent memory /CPU ratios in BIOS and CPU-Z
- Forumcpuz and bios show completely different speeds
- ForumDifferent FSB DRAM ratios shown in cpu-z and aida64
- ForumCore speed differs in CPU-Z and BIOS
- ForumVery low memory values in CPU-Z
- ForumHuge cpu-z core speed reading in prime95 priority 10
- ForumBios + Memtest report different timings then CPU-Z
- ForumCPU-Z shows 668 mhz frequency on ddr3 1600 pc how to increase speed ?
- ForumHELP with CPU-Z wrong cpu speed , bad timing!
- ForumCPUZ Memory Findings
- ForumGskill DDR2-1200 PC2-9600 memory reads as PC2-6400 (400 MHz) by CPU-Z
- ForumQ6600 "tape-mod" experts: CPU-Z showing different core speed !!!
- ForumMemory Nooob, aarrggghh! Using CPU-Z to set timings !!!
- ForumShould I follow the memory timings table in CPU-Z ?
- ForumPC hangs at BIOS screen after updating graphics driver.
- ForumFaulty Motherboard or Memory.... or something else
- ForumRAM speed or size?
- More resources
Read discussions in other Memory categories
!
