I notice when im even browsing a web page, it says core1 is at 50% load, or always signifigantly higher than the others. I dunno whats up, never used to run so hot. The computer is only 2 months old. I was having some trouble with it on startup, it would start, but would go into power saving on my monitor (which I checked cables, monitor, GPU is seated right) Now it works, but if I shutdown, then restart even a few minutes later, it goes into power saving mode again, no display. Maybe the 2 are related?
Hmm, I would grab HWmonitor so we can see what your gpu temp is while browsing compared to when its just idling on the desktop for about 5 minutes. Its possible that its overheating which causes the monitor to lose signal.
Also what is the ambient temperature in your room compared to in your case? (your motherboard should have a temperature probe for just general case temps, not the socket temp its usually called AUX or something similar, HWmonitor will also show you these temps)
If coretemp shows those temps then just use that if you feel like, I've never used core temp so I dunno.
Il check if that voides my warranty, because I bought this comp 2 months ago, and sometimes its fine, like 34 overall, and othertimes its rediculous, like when im doing nothign at all. THanks for the advice though. Most appreciated good sir.