Need assistance with memory timings

Hi,
I recently purchased 4GB G.skill memory kit (F3-12800CL7D-4GBRM)
I have set the memory speed to 1600 MHz and the voltage to 1.6 volts
I want to set the memory timings in bios but the bios reads incorrectly the SPD

I'm able to see the timing values via the everest software but i don't know to make the translation between the names used in the bios and the names used in everest

Here are the settings as they appear in the bios:
CAS# latency
RAS to CAS R/W Delay
Row Precharge Time
Minimum RAS Active Time
1T/2T Command Timing
TwTr Command Delay
Trfc0 for DIMM1
Trfc2 for DIMM2
Trfc1 for DIMM3
Trfc3 for DIMM4
Write Recovery Time
Precharge Time
Row Cycle Time
RAS to RAS Delay

Here are the settings name used by everest software:
CL
RCD
RP
RAS
RC
RFC
CR
RRD
WR
WTR
RTP


Thank you !
Alex
3 answers Last reply
More about need assistance memory timings
  1. No, the BIOS read the SPD chips properly. What happened is that the contents of the packaging didn't match the SPD chips.

    I suspect that you really bought overclocked RAM.

    What motherboard?
  2. the everest shows that the 1600 MHz speed achieved in XMP profile
    the motherboard is Gigabyte ma785gmt-ud2h revision 1.1 (i updated bios to last F9 version)
  3. sashakrik said:
    Hi,
    I recently purchased 4GB G.skill memory kit (F3-12800CL7D-4GBRM)
    I have set the memory speed to 1600 MHz and the voltage to 1.6 volts
    I want to set the memory timings in bios but the bios reads incorrectly the SPD

    I'm able to see the timing values via the everest software but i don't know to make the translation between the names used in the bios and the names used in everest

    Here are the settings as they appear in the bios:
    CAS# latency
    RAS to CAS R/W Delay
    Row Precharge Time
    Minimum RAS Active Time
    1T/2T Command Timing
    TwTr Command Delay
    Trfc0 for DIMM1
    Trfc2 for DIMM2
    Trfc1 for DIMM3
    Trfc3 for DIMM4
    Write Recovery Time
    Precharge Time
    Row Cycle Time
    RAS to RAS Delay

    Here are the settings name used by everest software:
    CL
    RCD
    RP
    RAS
    RC
    RFC
    CR
    RRD
    WR
    WTR
    RTP


    Thank you !
    Alex


    --------


    U can download CPU Tweaker from here install it, run it and u can know all the info that u need.

    Or u can wait until I arrive to my home (in eleven or twelve hours) and I can give u all those translate from my UD5.
Ask a new question

Read More

Memory BIOS Command Prompt