Good Evening,
Just assembled barebone kit. Everything was going fine until I switched on the PC. Monitor not working, No Signal message appears. It is not the monitor as I have tested it on other PC's.
Here's the kicker, when I remove the graphics card, I can see the display and load up windows.
In BIOS there is no section to turn off onboard graphics to AVG graphics, believe me I have been through BIOS searching for hours.
HELP! Any suggestions??
Just assembled barebone kit. Everything was going fine until I switched on the PC. Monitor not working, No Signal message appears. It is not the monitor as I have tested it on other PC's.
Here's the kicker, when I remove the graphics card, I can see the display and load up windows.
In BIOS there is no section to turn off onboard graphics to AVG graphics, believe me I have been through BIOS searching for hours.
HELP! Any suggestions??