Screw for Corsair H60 push pull
Last response: in Overclocking
If I was to set up a Corsair H60 in push-pull with two 25mm Enermax fans, (in the rear of the NZXT Phantom 410, if that helps any.) what screws would I need?
More about : screw corsair h60 push pull
Are you after extra screws for the second fan?
6/32 is the usual screw diameter, and you want 30mm length,
http://www.performance-pcs.com/catalog/index.php?main_p...
will see you right
Moto
6/32 is the usual screw diameter, and you want 30mm length,
http://www.performance-pcs.com/catalog/index.php?main_p...
will see you right
Moto
Related ressources:
- ForumSetting up the H60 to Push/Pull
- ForumH60 Corsair push and pull enough to OC i7 2600k to 4.5?
- ForumSetting up a push/pull configuration with a Corsair H60
- ForumCorsair H60 Push Pull Or ?
- ForumOptimal fans for H60 push-pull configuration.
- ForumH60 , Push vs Pull default instruc. Pull ?
- ForumCorsair H60 water cooling --> which config is better ???
- ForumCorsair H60 in 600t Case
- ForumCOOLER MASTER Seidon 120M vs Corsair H60 vs Antec Kuhler 620
- ForumSetting up my new Corsair H60 Kit
- ForumWhich case is better for using the Corsair H100 Push-Pull ???
- ForumNeed help. Any GT AP-15's + Corsair H50 ( push-pull ) combo users?
- ForumI5-3750k + H60 push/pull
- ForumCPU fan clicking?
- ForumThe Corsair H80i..? Will it fit?
- ForumCorsair H80 in Haf X
- ForumP8Z77-V DELUXE and Corsair Vengeance 4x4 GB Blue Scree Error
- Forum[Solved] Fans for the Corsair Carbide 400R
- ForumH60 3 pin pump header problem
- ForumWhat cpu aftermarket cooler is compatible with Corsair Vengeance?
- More resources
Read discussions in other Overclocking categories
