H-I41-uATX (Eton) manual

[dean_10]

Hi people. Not tryed using this before. I have bought the above board. I believe it is a board from a HP machine. I am after a manual or more specific the location of the F_panel wires. Any help would be much appreciated.
Deano

 

[Gekko Shadow]

F_Panel right above the Sata ports, lol.

 

[dean_10]

Hi there, thanks for the reply. I probably wasn't that clear. I knew the position however didn't know which wire went to which pin. Since this however I have found the location of pin 1. It has the little triangle next to it. So now I can use the basic intel pin layout to connect all other wires.
My problem has got longer however. I put an E2180 on the board along with 1 stick of 1GB 1Rx8 PC3-10600E-9-10-dp memory in slot 1 nearest cpu. I am getting a short beep followed by long beep. I removed all memory and am getting the same code so I suspect the memory is incompatible. Does anyone know what CPU and memory is compatible with this board. Many thanks Deano

 

[Gekko Shadow]

Well i tried searching for a cpu compatible list online - no luck yet. What you can also do is contact the manufacturer and asking them if they can verify what ram is supported.

From what i found it supports these two speeds:
* PC3-8500 (DDR3-1066)
* PC3-6400 (DDR3-800)

and Non-ECC memory only. If i'm not mistaken, your current memory is ECC. So it's not going to work =P. Hence the beeps. Try another 1GB stick that's non-ECC and see if that works =)

 

[dean_10]

Top man, I'll check Ebay out to find some different memory.

 

[Gekko Shadow]

Awesome let me know how that works out