EMCP73VT-PM replacement

[Guest]

Hello everyone,

I am looking at upgrading my board to something with more RAM capacity and also the current board does not support any type of overclocking without re programing the BIOS. I am also going the cheapest route and trying not to have to buy a new tower. I have the emachine et 1831 and this is the last upgrade I will need to make for now is this and was wondering if anyone could help.

Thanks

 

[shovenose]

um this is the power supply section?
while were in the power section, does your pc have the bestec atx-250-12e power supply? if it does, you will need a new power supply. that model is known to overvolt and fry motherbords

 

[tyree89733]

Get the Ultra X4 modular Power Supply Unit, its what i have installed in my ET-1810-01
(Note: Might be a little tight squeeze but open both side of the case and adjust dvd drive as needed to fit it all in)