Here is my computer that I just built http://pcpartpicker.com/b/Asx
I had overclocked it at 44 multiplier and left the voltage offsets alone.
Here it is at idle http://s22.postimage.org/foic29bep/idle.jpg
Here it is with prime95 http://s18.postimage.org/vjspds015/prime95.jpg
It ran good then blue screened so I move the offset +.015
Here it is at idle http://s1.postimage.org/ge94ciwr3/idle1.jpg
Here it is with prime95 http://s22.postimage.org/dmmg1r2td/prime951.jpg
The voltages are lower and it runs about 10C cooler in prime95.
Is this better or worse then it was before? Do I need more voltage and should change it to - offset or is this ok?
Also, I messed around with LLC and it wasn't very stable with voltage drooping so I leave it on auto.
Also, the mghz stock was 103 and I changed that to 100.
The ram I have is 2133 but was set one lower so I raised it back to stock
As for my GPU setup, I have 2 Sli GTX 660's (non-ti). I also messed around with 3dmax11, turning vsync on/off and testing.
This was my best run http://s17.postimage.org/rh69s0nfz/sli_gpu_non_oc.jpg
The GPU's are not overclocked yet. Do I need to raise the Vram only or what direction do I take with overclocking and reducing any bottle necking?
When I overclock the cards does it automatically do both of them? I haven't looking into overclocking gpus yet just build me computer.
Any help would be great, thanks
I had overclocked it at 44 multiplier and left the voltage offsets alone.
Here it is at idle http://s22.postimage.org/foic29bep/idle.jpg
Here it is with prime95 http://s18.postimage.org/vjspds015/prime95.jpg
It ran good then blue screened so I move the offset +.015
Here it is at idle http://s1.postimage.org/ge94ciwr3/idle1.jpg
Here it is with prime95 http://s22.postimage.org/dmmg1r2td/prime951.jpg
The voltages are lower and it runs about 10C cooler in prime95.
Is this better or worse then it was before? Do I need more voltage and should change it to - offset or is this ok?
Also, I messed around with LLC and it wasn't very stable with voltage drooping so I leave it on auto.
Also, the mghz stock was 103 and I changed that to 100.
The ram I have is 2133 but was set one lower so I raised it back to stock
As for my GPU setup, I have 2 Sli GTX 660's (non-ti). I also messed around with 3dmax11, turning vsync on/off and testing.
This was my best run http://s17.postimage.org/rh69s0nfz/sli_gpu_non_oc.jpg
The GPU's are not overclocked yet. Do I need to raise the Vram only or what direction do I take with overclocking and reducing any bottle necking?
When I overclock the cards does it automatically do both of them? I haven't looking into overclocking gpus yet just build me computer.
Any help would be great, thanks