Sign in with
Sign up | Sign in
Your question

Seatools for dos detecting stop

Last response: in Storage
Share
June 16, 2012 1:04:06 PM

I had problem with Harddisk which can not be recongized by Bios.

So I run the SeaTools for Dos (V2.23), but it was pending. I got following message from the Test Information and Results window:
------------------
Scanning for controllers....
Scanning for devices...
Scanning for devices on Generic PCI ATA...
Scanning for devices on Intel ICH6R....
------------------

It is pending, and waiting more than 10min, nothing happen. All other areas are empty or greyed.

Could you please advice what I shall d
a b G Storage
June 16, 2012 2:04:21 PM

Check the hard disk / controler settings in your BIOS. is this a new drive?
m
0
l
June 17, 2012 1:51:41 AM

anonymous1 said:
Check the hard disk / controler settings in your BIOS. is this a new drive?


it is an old Harddisk. It worked perfected a few days ago untill I forced to power off because it hanged up (I did such onec a while when a program hanged up in the past).

I checked the BIOS and connect to other computers, same problem. Can not be recongnized.
m
0
l
!