Just built system won't boot.

[henryrox]

I recently built the system and I'm having troubles booting it. None of the fans spin, the only thing that turns on is the front panel LED for about 5-10 seconds, then it turns off again. I' already have the 2-4pin's connected to the mobo and I'm pretty sure I have the led's correctly put in. Any suggestions?

 

[shortstuff_mt]

Sure, we have a lot of suggestions. They're all put together in a troubleshooting sticky at the top of the forum. There's also a link to the checklist in my signature. Let us know how it goes after you've performed EVERY step in the checklist.

 

[henryrox]

I looked through the sticky and I'm still having no luck.

 

[shortstuff_mt]

You have to do more than "look through" the checklist. The troubleshooting steps will tell you what the problem is 95% of the time if you actually perform EVERY step. You haven't really given us much to go on. What are your complete system specs? What troubleshooting steps have you already performed?

 

[jsc]

I looked through the sticky and I'm still having no luck.

 

[henryrox]

You have to do more than "look through" the checklist. The troubleshooting steps will tell you what the problem is 95% of the time if you actually perform EVERY step. You haven't really given us much to go on. What are your complete system specs? What troubleshooting steps have you already performed?

I've performed steps 1-12 so far and I can't seem to even get the fans spinning on anything including the PSU.

My specs are: AMD Phenom II X6 1055T
MSI 870A-G54 AM3 AMD 870
G.SKILL Ripjaws Series 4GB (2 x 2GB) 240-Pin DDR3 SDRAM DDR3 1600 (PC3 12800)
Thermaltake TR2 TRX-750M 750W ATX 12V v2.3 / EPS 12V.