Hello,
my main computer specs are the following:
CPU AMD Phenom X4 9100e (AM2+ Socket)
Gigabyte nForce 405 chipset (AM2) with BIOS upgraded to support AM2+ CPUs
2x2 GB DDR2 800 Mhz
VGA Radeon 5500 512 Mb PCI 2.0 Express
PSU 450W
Before this I had an AM2 Athlon X2 without this issue.
The system works ok but the sequence of booting is next:
1. Power button to start up system.
2. One beep (normal), no screen.
3. Two beeps (low volume) then a pause, and repeating this step (3) about 4 o 5 times. No screen.
4. A pause about few seconds.
5. Finally BIOS screen shows.
6. Loading operating system... etc
My question is if someone knows about why the beeps from step 3.
Maybe it can be motherboard (BIOS) trying to adjust frequency or memory with AM2+ Phenom HT (hypertransport is lowered on AM2 socket) link or something... but I don't know.
Thank you.
my main computer specs are the following:
CPU AMD Phenom X4 9100e (AM2+ Socket)
Gigabyte nForce 405 chipset (AM2) with BIOS upgraded to support AM2+ CPUs
2x2 GB DDR2 800 Mhz
VGA Radeon 5500 512 Mb PCI 2.0 Express
PSU 450W
Before this I had an AM2 Athlon X2 without this issue.
The system works ok but the sequence of booting is next:
1. Power button to start up system.
2. One beep (normal), no screen.
3. Two beeps (low volume) then a pause, and repeating this step (3) about 4 o 5 times. No screen.
4. A pause about few seconds.
5. Finally BIOS screen shows.
6. Loading operating system... etc
My question is if someone knows about why the beeps from step 3.
Maybe it can be motherboard (BIOS) trying to adjust frequency or memory with AM2+ Phenom HT (hypertransport is lowered on AM2 socket) link or something... but I don't know.
Thank you.