Memory ram ddr3 1.65v can i run with 1.5v port ?

Hello, ichange the port on moth' from 1.5v standerd to 1.64 as on memory spc.(1333-1.65v) .

is it ok or i reset change? or that valu is the maxmum of use or just overclocking value?

i don't try to overclocking but i want uasful lifetime
1 answer Last reply
More about memory ddr3 port
  1. Welcome to Tom's Forums! :)

    If you have an Intel based MOBO you can simply use the XMP setting, otherwise you'll need to set the DRAM Frequency -> DDR3-1333MHz ; DRAM Voltage -> 1.65v {closet value}, and preferably set the CAS Timings per RAM's Spec.

    As far as 1.50v vs 1.65v, if your RAM is rated at 1.65v @ Rated Speed e.g. 1333 MHz then you should use the correct values to reduce errors, and no running at rated has very little longevity impact verses Default SPD {e.g. 1066 MHz}.

    Q - What MOBO?
    Q - What RAM, I prefer a link?
Ask a new question

Read More

Chipsets Overclocking Memory Motherboards