Sign in with
Sign up | Sign in
Your question

Screws for board

Last response: in Motherboards
Share
June 6, 2011 3:54:00 AM

Which screws should one use to fasten baords to the brass things. The ones im using right now are the only ones that would fit into the fastenings these are little screws which look they have a built of a washer but isnt actually a washer. is this the correct screw these are the same one i use for my dvd drive. I'm trying to reduce vibration henc the question.

More about : screws board

a b V Motherboard
June 6, 2011 4:02:19 AM

#6-32 x 1/2" long screws - hex head, Phillips drive. Usually 6 screws and 9 stand-offs for an ATX motherboard.

Do not over-tighten.
!