Iomega 2TB Network Hard Drive

Hello. Recently I brought a Western Digital, 2TB Network Hard Drive, but couldn't get it to work, so took it back and changed it from an Iomega. Which worked straight away.

The problem I have, is when I set it up it automatically created six partitions. and named them, Music, Pictures, Etc. What I'd like to do is make it a single partition, which the full 2TB on it, and give it one single drive letter.

How do I do this please?

Many thanks in advance.
1 answer Last reply
More about iomega network hard drive
  1. Normally with these drives there is an IP address that you type into your browser to give you administrative access. Then you can setup the drive the way you like.

    The manual should tell you how to do this:
Ask a new question

Read More

Hard Drives Iomega Western Digital Storage