Sign in with
Sign up | Sign in
Your question

go no go go

Tags:
  • Components
Last response: in Components
Share
December 29, 2010 6:27:18 AM

the computor was in updates and said to reboot
now it will not boot ** it will turn on the screen comes on when stops **then starts again for a few seconds then stops
i have check the power the fans are turning no dust on board
it seem that it wants to start
it will not start in safe mode

so i can not go back to early save
this computor is 12 months old and had no problems
help

gigabyte GA-EP45T-EXTREME
INTEL E8500
RAM GEIL 4G 1600 DDR3
HARD DRIVE WD 1T CAVIER
DVD SATA DRIVE
ZALMAN CNPS9700 CPU FAN with adjust fan switch
ANTEC 200 BOX
HAS 5 CASE FANS

More about : question

December 29, 2010 2:06:56 PM

Its not clear if you can get to the bios or not? If yes, then double check your drives are set up properly - the type and boot order.

If you cant get to the bios, then its something more basic. Pull out everything and see if you can get to the bios. Could be RAM, power supply (you didnt say what you have) or other hardware. The point is to make it as simple as possible to troubleshoot.

If you get through POST and fails at the windows logo, then its still hardware or driver related. Those updates will - once in a while - completely feck up a system.
m
0
l
December 30, 2010 12:11:46 AM

using a gigibyte 750watt which i have put into another machine it powers up

i have pull the ram out and vid card out and tried in another machine also good
the hard drive tried in other machine its ok
no i can not get in to bios it turns it self off and then restarts

could it be the Zalman Fanmate2 Adjustable Fan Speed Connector
m
0
l
December 31, 2010 2:28:19 AM

vvhocare5 said:
Its not clear if you can get to the bios or not? If yes, then double check your drives are set up properly - the type and boot order.

If you cant get to the bios, then its something more basic. Pull out everything and see if you can get to the bios. Could be RAM, power supply (you didnt say what you have) or other hardware. The point is to make it as simple as possible to troubleshoot.

If you get through POST and fails at the windows logo, then its still hardware or driver related. Those updates will - once in a while - completely feck up a system.

using a gigibyte 750watt which i have put into another machine it powers up

i have pull the ram out and vid card out and tried in another machine also good
the hard drive tried in other machine its ok
no i can not get in to bios it turns it self off and then restarts

could it be the Zalman Fanmate2 Adjustable Fan Speed Connector


m
0
l
!