Sign in with
Sign up | Sign in
Your question

Bios was cleared on msi 7181.029 msi board do ineed new chip?

Tags:
  • Chipsets
  • BIOS
  • Chip
  • MSI
  • Motherboards
Last response: in Motherboards
Share
September 6, 2011 5:13:20 PM

where can I buy the new chip or is there another way of putting the bios into the old chip?
The prt no is 601-7181-020 it is in a msi k8mm3 computer mainboardms 781 ver 2.0 k8m3 h.
help me I hope
Dean

More about : bios cleared msi 7181 029 msi board ineed chip

a c 232 V Motherboard
September 6, 2011 6:15:14 PM

Why do you think you need a new BIOS chip? Clearing the BIOS does not mean you need to replace it. Rather, it means the BIOS was reset to its default state. Please clarify.
m
0
l
September 6, 2011 6:27:10 PM

COLGeek said:
Why do you think you need a new BIOS chip? Clearing the BIOS does not mean you need to replace it. Rather, it means the BIOS was reset to its default state. Please clarify.

m
0
l
Related resources
September 6, 2011 6:30:59 PM

HOW do I get I get it to start my computer the de fault state will not open my computer? what do I do?
Thanks for your reply
mathoe1
m
0
l
a c 232 V Motherboard
September 6, 2011 6:46:28 PM

How did you clear the BIOS? With the jumper (if so, be sure to put back into the default position after clearing) or by pulling the battery?
m
0
l
September 6, 2011 7:08:10 PM

COLGeek said:
How did you clear the BIOS? With the jumper (if so, be sure to put back into the default position after clearing) or by pulling the battery?

I used the jumper to

I used the jumper to clear it with the power off then I put the jumper back where it was but it wont recognize anything on start up.

mathoe1
m
0
l
September 6, 2011 7:11:59 PM

I used the jumper to clear it then put the jumper back where it was.I jumped it with the power off.
m
0
l
a c 232 V Motherboard
September 6, 2011 8:37:54 PM

Try this. Disconnect all power sources (power cable, powered speakers, monitor). Remove the motherboard battery. Press the power button to discharge any residual power left in the system. Wait a couple of minutes. Re-install the battery and reconnect the power sources and then attempt to re-boot the system.
m
0
l
!