Holding a wire in the motherboard

[aajohnny]

Hey,
My computer case connector thing is very loose and disconnects in a second and because of that I have to turn my computer on from the motherboard, unless I literally hold in the connector to the motherboard, is there any material or something I can use that won't mess my computer up that can hold the connector in?

 

[pjmelect]

Blue Tac? or you could solder the wires. I have never seen this problem in all of the thousands of computers that I have fixed, can you be more specific?

 

[aajohnny]

Sure, i'll try.

The plug from my case (to press the power button to turn on the computer) is always loose and there is a slot on my motherboard that it hooks into so that it works. It is always loose and unhooks so that means I can't turn the power on my computer through the case because the plug isn't connected or is loose, so I have to press the power button on my motherboard to turn my computer on. I was wondering if there was a specific tape or something that I can just hold the plug tight to my motherboard without problems.