A little confused.

[browserz]

http://www.newegg.com/Product/Product.aspx?Item=N82E16813130305

I bought this product without actually looking at the reviews, and i bought this ram.

http://www.newegg.com/Product/Product.aspx?Item=N82E16820231311

In my eyes it would run fine but apparently it doesnt. I got the system to work for 2 weeks but after that i keep getting a blue screen that says "Page fault in nonpaged area".

After reading the reviews i read this comment:

Spoiler

Other Thoughts: CPU will not overclock unless you use switch on MB. In the BIOS there is no way to use a different multiplier even if it is lower. ie: if you use a E5800 CPU it has a 16 multiplier. (16x200FSB=3.2Ghz)There is no way to use any other multiplier than the 16 not 15,14 etc. (9x333=3.0Ghz is not possible). If the processor has a .5 step there is no way to allow/disallow as on many other G41 MB's. Also tried multiple brands of DDR3 1333 memory( G.Skill Sniper,Patriot Extreme,Corsair Vengeance you get the picture) none would run at 1333Mhz. The board would try to boot mutiple times and then reset the memory to 1066Mhz and boot fine. Yes I messed with the voltage settings all over the place. Same results. The board works OK with the above caveats.

How do i reset the memory to 1066Mhz? From what i've read, the page fault in nonpaged area means that my ram is the problem, i would really not like to buy new ram as i would have no use for this ram that i bought =l is there anything that i can do to make my computer work again?

Here are my computer specs that might come in handy if you guys need it.

Q6600 processor
Nvidia 450gts
700w power supply

Thanks alot in advanced!

 

[browserz]

Anyone? I'd like to be able to use my computer again...

 

[dayto11]

onlying i can think of is resetting the bios then it should run on the defult factory ram setting.