Switched to AHCI from RAID0, Recoverable?

Ok, I think I figured it out. It says bootable now, but I've got the Blue screen on windows load up.

I sincerely hope that you have backups. My usual reaction to a Windows that loads part-way but fails to complete is a repair install, booting from the distro, but in this case I would not - further writing to the damaged array may just cause more damage.

Most cases that I have seen of booting with RAID drives taken out of RAID have been pretty hairy. Let me poke around for some of the better success stories...
http://www.tomshardware.com/forum/243688-32-failed-reco...
http://www.tomshardware.com/forum/281436-32-raid0-recov...

Good luck! Tell us what works.

Thanks for the reply... what I ended up doing was recovering the important stuff through software. Then, clean install. Decided I won't be doing RAID0 again.