Any recommendations on making my SpinQ Thermaltake install easier??

[slayerbizkit]

I've been using this cooler for about 2 years now and it's gotten to the point where the snap-in bolt pin things barely work. I use the diagonal method outside the case to snap them in but they're simply too worn out to snap in place anymore and I don't want to take the risk of installing it half-way and having a big ass cooler flap around and shred things inside my computer tower.

I'm looking at possibly buying this:
http://www.frozencpu.com/products/10066/cpu-tri-70/Thermalright_LGA_1156_Bolt-Thru-Kit_Rev_B_Ultra_Series_MUX-120_IFX-14_Venomous_X_Ultima_90_Cogage_True_Spirit_.html?tl=g48c371s441&id=wCwIxAF7

But I'm not sure if this will work. Any recommendations as to how to remedy this problem?

I have an 1155 motherboard if that helps. Thanks

P.S.: Fixed the link

 

[Ubrales]

The 1156 bolt-thru kit should work on the 1155. And this method of securing the heatsink is better than the snap-in method. Tighten the screws in a diagonal pattern, in small incremental steps. Check torque requirements and do not over tighten.

(Please check the link again)