RAM for Ivy Bridge

Ivy Bridge CPU (not going to overclock)
Corsair Vengeance (low profile)

What voltage should I get - 1.5v or 1.35v?
4 answers Last reply
More about bridge
  1. The 1.35V is just fine as well. I would go with this one, if there is a choice : ))

    http://www.newegg.com/Product/Product.aspx?Item=N82E16820233199

  2. steve360 said:
    Ivy Bridge CPU (not going to overclock)
    Corsair Vengeance (low profile)

    What voltage should I get - 1.5v or 1.35v?


    I don't see any reason to spend more on low voltage ram.
    Also, sandy bridge, (and presumably ivy bridge) is insensitive to ram speeds.
    http://www.anandtech.com/show/4503/sandy-bridge-memory-scaling-choosing-the-best-ddr3
    Fancy heat spreaders are not needed for 1.5 v ram; they are mostly for marketing.
    Spend any savings elsewhere, and look at a kit like this:
    http://www.newegg.com/Product/Product.aspx?Item=N82E16820231422

    If you are buying a ivy bridge "K" cpu, preserve your option to OC by using a motherboard with a chipset capable of overclocking. Z68, Z77...etc.
  3. I agree with above and every time I see buying components before a CPU is released often ends in disappointment. There will be kits, more than likely, with both XMP and 'SPD' that are tailored and tested for the IB.

    All I know is that the IMC is similar to the current SB-E and DDR3-1600 is added to its base frequency.

    The 1.35v RAM kits, my experience with my 8x4GB (2 kits) of Vengeance is they're great at both Rated (manual) and XMP, but the couple times I tried to OC to DDR3-1866 ended-up in post failures. note: at the fraction of time I was testing my Sabetooth X79 was diying a fast death so I didn't need a complication. My general experience with Vengeance is that their IC's are not in leagues with Dominators and OC'ing 8 sticks is a boat load different than 2 sticks. However, the 1.35v kits I had gave me the best numbers I've seen from a DDR3-1600 CAS 9 kit.

    Therefore, if I had to buy I'd probably look at an X79 kit DDR3-1600 CAS 9 and if not OC the RAM the Vengeance but OC'ing the RAM defiantly the Dominators. Further, as mentioned the 1.35v are indeed more expensive, but they are also the easiest on the CPU.

    Kits to consider (but note comments above) - http://www.corsair.com/memory/intel-memory-upgrades/quad-channel-intel-memory-upgrade-kits.html

    IMO - Wait as the best choice.
Ask a new question

Read More

Memory Overclocking RAM CPUs Corsair