This case supports 2 front 120mm fans, 1 side fan, 2 top fans and 1 rear.
Currently I have
3 Antec Tricools, has 3 settings, which have the ratings of
Speed CFM
Low 1200 39
Med 1400 56
High 1600 79
3 CM Stock Case fans,
1200 44
And 1 Kingwin
950 40
I have the Hyper 212+ Heatsink, which has a rating of Rpm 600-2000, CFM 21.2-76.8
Currently this is mounted facing upwards which I may change. Also debating maybe sticking one of the tricools on high and put that as a pull fan on the heatsink.
Currently I have 2 tricools in the front intake on Med, and Tricool on Medium on side intake.
The 3 CMs i have as exhaust on the 2 upper and 1 rear.
Should I move the kingwin to the front and use one of the tricools for the pull?
Is pull not as critical and I could use a CM fan? So clueless here.
Currently I have
3 Antec Tricools, has 3 settings, which have the ratings of
Speed CFM
Low 1200 39
Med 1400 56
High 1600 79
3 CM Stock Case fans,
1200 44
And 1 Kingwin
950 40
I have the Hyper 212+ Heatsink, which has a rating of Rpm 600-2000, CFM 21.2-76.8
Currently this is mounted facing upwards which I may change. Also debating maybe sticking one of the tricools on high and put that as a pull fan on the heatsink.
Currently I have 2 tricools in the front intake on Med, and Tricool on Medium on side intake.
The 3 CMs i have as exhaust on the 2 upper and 1 rear.
Should I move the kingwin to the front and use one of the tricools for the pull?
Is pull not as critical and I could use a CM fan? So clueless here.