Sign in with
Sign up | Sign in
Your question

P6310f gtx 465

Last response: in Graphics & Displays
Share
February 16, 2011 3:04:21 AM

I recently bought a PNY gtx465 1gig for my HP p6310f i upgraded to a Rosewill RG630-s12 psu. Im getting a lot of system lockups some within minutes of starting the system, i'm not sure if i have a faulty card or if too much heat is being generated and building up inside. I was wondering what suggestions you might have ... is the card too much for the psu, is it likely the case has heat issues and what can i do about it... etc.

Thanks in advance.

More about : p6310f gtx 465

February 16, 2011 3:46:01 AM

Can you boot up long enough to get the temps?
m
0
l
February 16, 2011 3:56:27 AM

yes i can and i actually adjusted the gpu fan as it did not seem to ramp up with the temp but the gpu temp did fluctuate wildly even with my case open. It will often run for a while but eventually i get a system lock usually when i'm not paying attention and i can't seem to find a event log for it, although i just might be looking in the wrong place. I have removed the card for the time to figure out what to try next.
m
0
l
Related resources
February 16, 2011 11:46:19 AM

ok i found this in the event viewer this morning when i tried with lower part of front panel off to help venting. Starting to think maybe the PSU isn't giving enough power for some reason?

- System

- Provider

[ Name] Microsoft-Windows-Kernel-Power
[ Guid] {331C3B3A-2005-44C2-AC5E-77220C37D6B4}

EventID 41

Version 2

Level 1

Task 63

Opcode 0

Keywords 0x8000000000000002

- TimeCreated

[ SystemTime] 2011-02-16T13:23:56.087600000Z

EventRecordID 132404

Correlation

- Execution

[ ProcessID] 4
[ ThreadID] 8

Channel System

Computer nhjbm-PC

- Security

[ UserID] S-1-5-18


- EventData

BugcheckCode 0
BugcheckParameter1 0x0
BugcheckParameter2 0x0
BugcheckParameter3 0x0
BugcheckParameter4 0x0
SleepInProgress false
PowerButtonTimestamp 0
m
0
l
February 23, 2011 1:32:01 PM

Just to update,

I changed to two straight 6 pin connectors (instead of using the included adapter) and using afterburner chose the reset option at the bottom which seemed to correct a fan issue. so now its running well. Hopefully it stays that way!
m
0
l
!