Sign in with
Sign up | Sign in
Your question

Help! DDR3 Dilemma! (For my HP - P6620F)

Last response: in Memory
Share
April 6, 2012 11:20:46 AM

Here I go again! I have an HP, P6620F (with the PhenomII X4 830.) The mobo is being replaced, under warranty. (Foxconn mobo in there now.) Now, I'm trying to figure out which memory I can use/get away with. I'm looking at the G.Skill Ripjaw's on, Newegg. This is my dilemma, 10600 or 10666? I've seen them as considered the same thing. I see all kinds of, 9-9-9-24 with the occasional "2N" slapped in there. (D'OH!) I see something in the stats that says, "2T". (Command rate?) Right now, because of prices being somewhat affordable, I was thinking of going right up to 16 GIG! (2 kits of 2 X 4 GIG) I have a GIGABYTE GT440 GPU and a ROSEWILL 500 watt PSU thus far. What I have going on in here now, memory wise. (Below) Suggestions? Am I thinking too big? Overkill perhaps? My thoughts on going 16 GIG is being able ot get it, BEFORE prices skyrocket for whatever reason! I just need to figure out which to buy.

Memory slots
Total memory slots 4
Used memory slots 3
Free memory slots 1
Memory
Type DDR3
Size 6144 MBytes
Channels # Dual
DRAM Frequency 666.7 MHz
CAS# Latency (CL) 9 clocks
RAS# to CAS# Delay (tRCD) 9 clocks
RAS# Precharge (tRP) 9 clocks
Cycle Time (tRAS) 24 clocks
Bank Cycle Time (tRC) 33 clocks
Command Rate (CR) 2T
Physical Memory
Memory Usage 33 %
Total Physical 5.75 GB
Available Physical 3.83 GB
Total Virtual 11 GB
Available Virtual 8.95 GB
SPD
Number Of SPD Modules 3
Slot #1
Slot #2
Slot #3


More about : ddr3 dilemma p6620f

April 7, 2012 10:00:01 AM

The link for the RAM I did put as a reply so I could get a second opinion perhaps. Also, because I forgot to include it in my original post. I'm guessing that it's ok then, considering I've recieved no replies, period.
!