Sign in with
Sign up | Sign in
Your question
Closed

Network security

Last response: in Wireless Networking
Share
Anonymous
a b 8 Security
December 29, 2010 4:17:53 PM

Hello,
is there a way to assign a security key to an existing network that currently has no key?

More about : network security

a b 8 Security
December 29, 2010 5:21:06 PM


Go Start then Run in XP - Windows key plus R in Vista and Windows 7, then type in the following, including all the spaces:-

cmd /k ipconfig /all

then press Enter and from the black form that shows up, take a note of the numeric code beside the Default Gateway icon - something like 192.168.0.1.

Type exit to close the black form.

Open Internet Explorer and enter that code into the URL address bar as though it was a website. You're then at the login page to the router's settings utility and admin will usually be the login with either admin or password as the password.

If you're in, seek out Wireless and then Security and take a note of the key. Sometimes it may be a passphrase, some a simple set of letters and others a hexadecimal code. You also may as well note which level of security it is - WEP, WPA or WPA/PSK 2 and then either AES or TKIP. Your computer will already know this but it's handy information to store. Note also that hexadecimal only contains numbers from zero to 9 and letters a to f so there's no confusion of I and O with 1 and 0.

Keep a note of that security key in My Documents and also outside the computer so you don't have to go through this again and I don't have to write it all out again. :D 

Anonymous
a b 8 Security
December 30, 2010 10:39:57 AM

This topic has been closed by Grumpy9117
!