Bad reset switch

[bradf57]

Hello,
I just did a new build, the case is a old atx tower (Antec) and the reset switch went on it. So now I have to figure out what type of switch to replace it with. The only thing I can figure is it would have to be a dc switch and probably very low powered one. Not sure on the specs for one. Also maybe were I can buy one. No need for fancy lights or anything just a push button.

 

[Paperdoc]

Yes, it is a low-voltage, low-amperage switch. It is a momentary-contact Normally Open (NO) switch. Its contacts are open at all times except when you push it - then a connection is made, but broken again as soon as you stop pushing and the spring action pops the button back out. A very simple switch.

 

[COLGeek]

You really don't need the reset switch. You could simply disconnect it.

 

[inzone]

http://www.performance-pcs.com/catalog/index.php?main_page=product_info&cPath=60_374_803&products_id=31007

This is as basic as you can get.

 

[bradf57]

Best answer selected by bradf57.

 

[bradf57]

http://www.performance-pcs.com/catalog/index.php?main_page=product_info&cPath=60_374_803&products_id=31007

This is as basic as you can get.

Thanks just ordered two of them. I'm not a case modder so this will work perfect.

Brad

 

[Mousemonkey]

This topic has been closed by Mousemonkey