Motherboard: MSI P67A-G43 (B3)
SSD: 2x Corsair 120GB Force 3
HD: 1x 1TB Seagate
Hello,
I just purchased a second Corsair 120GB SSD. One of the Corsair has Windows seven on it the other is blank. I am trying to enable the two drives into Raid 0 and have been following this simple guide;
http://www.corsair.com/blog/configuring-raid-0-arrays-with-solid-state-drives-intel-ich-and-pch-controllers/
I get to the following step;
CTRL-I
After rebooting, the BIOS will prompt you to press CTRL-I to enter the RAID Configuration Utility.
But after rebooting I do not get prompted to press CTRL-I as the screenshot shows and instead my computer tries to boot into windows, and gets a BSOD. The best piece of information I could find was a suggestion from the Intel site to enable "Addon ROM Display", but I could not manage to find that or a similar option. Article found here;
http://www.intel.com/support/motherboards/desktop/sb/cs-020811.htm#ctrli
Any advice on how to solve this problem would be greatly appreciated!
SSD: 2x Corsair 120GB Force 3
HD: 1x 1TB Seagate
Hello,
I just purchased a second Corsair 120GB SSD. One of the Corsair has Windows seven on it the other is blank. I am trying to enable the two drives into Raid 0 and have been following this simple guide;
http://www.corsair.com/blog/configuring-raid-0-arrays-with-solid-state-drives-intel-ich-and-pch-controllers/
I get to the following step;
CTRL-I
After rebooting, the BIOS will prompt you to press CTRL-I to enter the RAID Configuration Utility.
But after rebooting I do not get prompted to press CTRL-I as the screenshot shows and instead my computer tries to boot into windows, and gets a BSOD. The best piece of information I could find was a suggestion from the Intel site to enable "Addon ROM Display", but I could not manage to find that or a similar option. Article found here;
http://www.intel.com/support/motherboards/desktop/sb/cs-020811.htm#ctrli
Any advice on how to solve this problem would be greatly appreciated!