Just purchased a new MOBO / memory & APU as below to replace my ageing rig.
I need dual monitors running as I use the rig as a Karaoke / DJ. In my old giga board I output via the VGA port to Karaoke screens the DVI to my screen.
Problem is no matter how I config this board, I can not get it to see two monitors plugged into the VGA & DVI ports. I know if I enable dual DVI output in the BIOS it disables ALL the other ports, but when I do this I get a max resolution of 860 which can not be changed. If I disable the Radeon driver and use the stock Windows 7 driver I can get full range of resolution !.
I disable the BIOS dual DVI option and the board will not see the DVI monitor but will see it if I plug it into the VGA port.
First system I have built with the FM1 footprint.
The other thing is the rear on board USB ports will not recognise anything plugged in on POST, until Windows boots up.
Is this a fault on the board or have I over looked something?
Main Hardware Information:
CPU AMD 3870K 3GHz Socket FM1 4MB L2 Cache Retail Boxed Processor
RAM Kingston 2GB DDR3 1600MHz HyperX Blu Memory CL9 1.65V (x2)
Motherboard Gigabyte GA-A75M-UD2H A75 Socket FM1
Video Card Non
Other Hardware Information :
Monitor Acer P233W
HDD/SSDs Samsung 80GB SATA
Operating System : Windows 7 x64
Video Card Drivers in Use ( and tried ): MOBO Driver CD (Latest Catalyst)
Motherboard Drivers Used: MOBO Driver CD
System clean of viruses / spyware etc: Clean Install
Other things tried: Valium – for frustration