Hi
Kindly help me on this, i am trying to break cisco pix515e series firewall, but its not happaning, i have done below configuration
monitor> interface eth1
0: i8255X @ PCI(bus:0 dev:14 irq:10)
1: i8255X @ PCI(bus:0 dev:13 irq:11)
Ethernet auto negotiation timed out.
Ethernet port 0 could not be initialized.
monitor> address 10.21.1.99
Invalid or incorrect command. Use 'help' for help.
monitor> server 172.18.125.3
server 172.18.125.3
monitor> interface eth1
0: i8255X @ PCI(bus:0 dev:14 irq:10)
1: i8255X @ PCI(bus:0 dev:13 irq:11)
Ethernet auto negotiation timed out.
Ethernet port 0 could not be initialized.
monitor> address 10.25.1.99
address 10.25.1.99
monitor> file np70.bin
file np70.bin
monitor> ping 172.18.125.3
Sending 5, 100-byte 0x1b6a ICMP Echoes to 172.18.125.3, timeout is 4 seconds:
Success rate is 0 percent (0/5)
monitor> ping 172.18.125.3
Sending 5, 100-byte 0x1b6b ICMP Echoes to 172.18.125.3, timeout is 4 seconds:
Success rate is 0 percent (0/5)
monitor> tftp
tftp np70.bin@172.18.125.3
TFTP failed (return:-1 arg:0x0)
monitor>
Its getting so many errors like shown above please give me the way as early as possible
Thanks
Suresh A
Kindly help me on this, i am trying to break cisco pix515e series firewall, but its not happaning, i have done below configuration
monitor> interface eth1
0: i8255X @ PCI(bus:0 dev:14 irq:10)
1: i8255X @ PCI(bus:0 dev:13 irq:11)
Ethernet auto negotiation timed out.
Ethernet port 0 could not be initialized.
monitor> address 10.21.1.99
Invalid or incorrect command. Use 'help' for help.
monitor> server 172.18.125.3
server 172.18.125.3
monitor> interface eth1
0: i8255X @ PCI(bus:0 dev:14 irq:10)
1: i8255X @ PCI(bus:0 dev:13 irq:11)
Ethernet auto negotiation timed out.
Ethernet port 0 could not be initialized.
monitor> address 10.25.1.99
address 10.25.1.99
monitor> file np70.bin
file np70.bin
monitor> ping 172.18.125.3
Sending 5, 100-byte 0x1b6a ICMP Echoes to 172.18.125.3, timeout is 4 seconds:
Success rate is 0 percent (0/5)
monitor> ping 172.18.125.3
Sending 5, 100-byte 0x1b6b ICMP Echoes to 172.18.125.3, timeout is 4 seconds:
Success rate is 0 percent (0/5)
monitor> tftp
tftp np70.bin@172.18.125.3
TFTP failed (return:-1 arg:0x0)
monitor>
Its getting so many errors like shown above please give me the way as early as possible
Thanks
Suresh A