/ Sign-up
Your question

SYSTEM problem?

  • Prebuilt
  • Motherboards
  • Printers
  • Systems
Last response: in Systems
October 11, 2011 1:15:19 AM

I have CNC PCB drilling machine. The PC which was running the machine was connected to printer port. The other port (25 pin ) had a dongle (hardware lock) to recognise the authorisation. The data IO card is inserted on the motherboard. The machine runs on MSDOS versions only. If used with win 98 /dos it stops running.
Suddenly PC motherboard went bad. The other motherbord if replaced runs for sometime then machine hangs . Could we get possible reasons?

More about : system problem

a b V Motherboard
October 12, 2011 5:56:44 AM

Hello chetan13;

Possibly a driver issue.
Did you replace the motherboard with an identical model?