Archived from groups: rec.photo.digital (More info?)
Wanting to put an internal card reader in my PC. Months ago, I looked at
some at a Fry's and was confused as to how it would connect to the
motherboard. It seemed there were many different connections to make and I
wasn't up to the challenge. I noticed from reading some posts that some,
however, connect with a USB cable from the back of the unit, throught the
case and out a PCI knockout to plug into a normal USB posrt.
Any experience with these two types and if the USB works fine?
TIA,
Nottoman
Archived from groups: rec.photo.digital (More info?)
In article <ZOWdndvQGMbvSvbfRVn-tQ@comcast.com>, 02befree
<nottoman@hotmail.com> wrote:
> Any experience with these two types and if the USB works fine?
No reason why the snake-through cable setup wouldn't work exactly the
same as one that's connected directly to the motherboard.
However, most motherboards have two back-panel connectors and two
internal or front-panel connectors. It's slightly daunting to figure
out the cabling for the internal connectors, but much neater. The card
reader should have instructions for what signal goes on what wire, and
the oinouts for the motherboard should be available from its
manufacturer.
You'll also find lots of help on the internet. Google "internal usb
pinouts" or "internal usb header".
Archived from groups: rec.photo.digital (More info?)
You can always pick up a USB PCI card with an inside connection and install
it. Not very expensive and solves the problem. Otherwise, snaking it
through the an open slot in the back is no big deal.
The problem is that not all motherboards have internal USB connectors, and
you would need the motherboard documentation to resolve that problem.
"02befree" <nottoman@hotmail.com> wrote in message
news:ZOWdndvQGMbvSvbfRVn-tQ@comcast.com...
> Wanting to put an internal card reader in my PC. Months ago, I looked at
> some at a Fry's and was confused as to how it would connect to the
> motherboard. It seemed there were many different connections to make and
> I
> wasn't up to the challenge. I noticed from reading some posts that some,
> however, connect with a USB cable from the back of the unit, throught the
> case and out a PCI knockout to plug into a normal USB posrt.
> Any experience with these two types and if the USB works fine?
> TIA,
> Nottoman
>
>
Archived from groups: rec.photo.digital (More info?)
Hi,
Slightly off subject but I just got an 8 in 1 card reader at Fry's in
Wilsonville (near Portland, Oregon). Has USB 2.0 and cables into USB
port on computer(s).
Fry's has advertised specials on multiple card readers over the past
few weeks/months as low as $6.99. Mine was on sale at $9.99 and works
just fine. I was impressed at the transfer rate using USB 2.0 vs. 1.0.
Pretty spiffy.
I use the card reader with both an iBook (Mac) and Gateway laptop (Win
XP).
Archived from groups: rec.photo.digital (More info?)
02befree wrote:
> Wanting to put an internal card reader in my PC. Months ago, I looked at
> some at a Fry's and was confused as to how it would connect to the
> motherboard. It seemed there were many different connections to make and I
> wasn't up to the challenge. I noticed from reading some posts that some,
> however, connect with a USB cable from the back of the unit, throught the
> case and out a PCI knockout to plug into a normal USB posrt.
> Any experience with these two types and if the USB works fine?
> TIA,
> Nottoman
>
>
The USB will work great, especially if it is USB 2.0 High-speed. It is
also possible that your motherboard may have an internal USB port (many
do) to which you can connect the cable. The unit should have a jack for
power, and the signal cable to a USB port. No other connectors should
be necessary.
Archived from groups: rec.photo.digital (More info?)
Conrad,
Many thanks,
I'm in Beaverton, so the Fry's in Wilsonville is the one I shop at also.
Best Regards,
"Conrad" <Conrad.1o0otn@no-mx.Newsgroup.Gateway> wrote in message
news:Conrad.1o0otn@no-mx.Newsgroup.Gateway...
>
> Hi,
>
> Slightly off subject but I just got an 8 in 1 card reader at Fry's in
> Wilsonville (near Portland, Oregon). Has USB 2.0 and cables into USB
> port on computer(s).
>
> Fry's has advertised specials on multiple card readers over the past
> few weeks/months as low as $6.99. Mine was on sale at $9.99 and works
> just fine. I was impressed at the transfer rate using USB 2.0 vs. 1.0.
> Pretty spiffy.
>
> I use the card reader with both an iBook (Mac) and Gateway laptop (Win
> XP).
>
> Best,
>
> Conrad
>
>
> --
> Conrad
Archived from groups: rec.photo.digital (More info?)
"02befree" <nottoman@hotmail.com> wrote in message
news:ZOWdndvQGMbvSvbfRVn-tQ@comcast.com...
> Wanting to put an internal card reader in my PC. Months ago, I looked at
> some at a Fry's and was confused as to how it would connect to the
> motherboard. It seemed there were many different connections to make and I
In practice, its usually quite simple. Internal USB headers are simple 4 pins
in a line. At the very worst, their are only two ways to try. } Vitually all
modern PC motherboards have at least two internal USB headers. You
simply plug the one (or two) cables from the internal reader onto one (or two)
of the internal headers.
> wasn't up to the challenge. I noticed from reading some posts that some,
> however, connect with a USB cable from the back of the unit, throught the
> case and out a PCI knockout to plug into a normal USB posrt.
> Any experience with these two types and if the USB works fine?
....
Both "types" are really identical. Both will work just as well.
Internal cable. External cable. External cable passing through the
case. Its all the same. Do whatever seems easiest and best to you.
Personally, I like internal FLASH card readers and I hook them to the
internal USB ports.
--
Dan (Woj...) [dmaster](no space)[at](no space)[lucent](no space)[dot](no
space)[com]
===============================
"The sky turned to black / Would he ever come back?
They would climb a high dune / They would pray to the moon
But he'd never return / So the sisters would burn
As their eyes searched the land / With their cups full of sand"
You are about to answer a thread that has been inactive for more than 6 months. If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.