Moving HP slimline components into nzxt vulcan case

Hello. This is my first thread. I recently got a new case for Christmas along with a 500w power supply. I'm having issues trying to connect the new case's wires with my motherboard (Cupertino2 motherboard) The HP slimline i have is an s5 1234. I can't really tell how i should wire it being my first time. Its confusing to see multiple sockets for me to fit the reset switch as well as power led ect.

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c02978278&tmp_task=prodinfoCategory&cc=us&dlc=en&lc=en&product=5233469

It is a matx case and I'm stuck on wiring the technical stuff so that it can actually function.

Thanks in advanced. Please, inform/teach me as i'm still new to computer crafts.
1 answer Last reply
More about moving slimline components nzxt vulcan case
  1. I'm not sure if you guys can see but on the motherboard there are two identical pin ports that are labeled F_USB1 and F_USB2, then to the right is a F_PANEL in which i'm trying to figure out where to place my USB2.0 RESET SW & POWER SW pins into. Thanks
Ask a new question

Read More

Motherboards Cases Hewlett Packard Components