Sign in with
Sign up | Sign in
Your question

Beeps code for asus motherboard

Last response: in Motherboards
Share
January 17, 2013 11:44:56 PM

Hello,

My computer says it's suffered a fatal error and now is doing a series of beeps whenever it's turned on. It does not stay on-only momentarily and then the box comes up with the "fatal error" message and then a few minutes later it will loop back into restart. Any ideas on what's wrong with it? Oh also, it beeps 1 short beep whne it powers off and then the screen turns black and then the Windows logo comes up as it starts to reboot once again. That's it's entire cycle.
a b V Motherboard
January 18, 2013 10:52:37 PM

1. What is the Asus Motherboard model?
2. What is the code? how many beeps, pauses etc.

In case you want to look for yourself, the specific model's user manual should include the beep codes for it. you can download the user manual from the Asus website \ Support \ motherboard model \ downloads.
m
0
l
a c 307 Ĉ ASUS
a c 1221 V Motherboard
January 18, 2013 10:53:58 PM

This topic has been moved from the section Windows XP to section Motherboards & Memory by SR-71 Blackbird
m
0
l
August 21, 2014 12:20:35 PM

try this site
http://support.asus.com/pcassistant/pdf/BeepTable_en-us...

if you can't read PDF then...
If your scren (monitor) stays blank with nothing displayed, please kindly folow the folowing bep codes sugestions: with relative
Warning
Beep: Reason: Suggestion:
One long, two short:
Cannot detect any RAM installed
Please try the following suggestions in turns to resolve this issue:
1. Try re-installing the RAM module.
2. Try installing the RAM module onto other DIMM slots.
3. Clean the golden finger on the RAM module with white eraser, and
clean the memory slot with soft brash, then install the memory back
onto the slot.
4. Please replace your memory module

One short VGA card test OK No actions required.

One long, three short:
Cannot detect any VGA card or VGA card test fail
Please try the following suggestions in turns to resolve this issue:
1. Try re-installing the VGA card.
2. Try installing the VGA card onto other DIMM slots.
3. Clean the golden finger on the VGA card with white eraser, and clean the expansion slot with soft brash, then install the VGA card back onto the slot.
4. Please replace your VGA card
:capables of displaying POST mesage on the screen, please kindly follow the folowing beep codes
Warning
Beep: Reason: Suggestion:

One short: Cannot detect keyboard.
Please try the following suggestions in turns to resolve this issue:
1. Try re-connect the keyboard after shutted down your system.
2. Try replacing your keyboard.

Two short: Hard disk test failed (S.M.A.R.T. test failed, or cannot detect hard disk.)
Please try the following suggestions in turns to resolve this issue:
1. Try replacing your IDE/SATA cable connected to your hard disk.
2. Try replacing your hard disk.

Four short:
Hardware monitor detects error (abnormal temperature, voltage, fan speed)

One short: All other errors found at POST stage.
Please refer to error message on the screen to locate the cause of this fault, and correct it accordingly.
m
0
l
!