/ Sign-up
Your question

I changed the graphics settings to LVDS in the Bios and now the screen is blank

  • Graphics Cards
  • BIOS
  • Graphics
Last response: in Graphics Cards
October 13, 2011 9:57:08 PM

I have changed, in the BIOS, the graphics setting to the LVDS setting. The screen wnet blank and now I am unable to access the bios or anything else. Does anyone know how to access the Bios again in order to change it back?
I have tried hittting the F2 key with no luck. I have removed the CMOS battery and plugged it back in hoping the BIOS would revert to the defaults. No luck. Any other suggestions?

More about : changed graphics settings lvds bios screen blank

a c 927 U Graphics card
October 15, 2011 4:07:37 AM

There should be a jumper block on the board to reset the BIOS to factory. Your manual should point it out. Move the jumper from where it is to the adjacent pins, wait a few seconds, move it back.