Hello everyone! I've been purchasing parts for building my own computer, and I've put what I have together and my PC won't start. Here's what I've got:
-ASUS P8P67 PRO motherboard
-Intel Core i7 2600k processor
-Corsair Vengeance 16GB DDR3 RAM (4x4)
-ePower EP-600PM power supply
-Antec Six-Hundred V2 case (irrelevant)
I installed my CPU the other night, and the board was running for a good two to three minutes until shutting off on its own. Since then, whenever I attempt to power up the board, it will get surge of energy, the CPU fan does a quarter-spin and then stops.
The standby LED on the board is on when plugged in, and that's it. I've tried just about everything: clearing the RTC RAM in CMOS, removing and re-installing the battery, etc.
This is not a RAM issue, because the board's behavior remains the same when no RAM is present. Help would be appreciated! I hope I didn't screw anything up :/
-ASUS P8P67 PRO motherboard
-Intel Core i7 2600k processor
-Corsair Vengeance 16GB DDR3 RAM (4x4)
-ePower EP-600PM power supply
-Antec Six-Hundred V2 case (irrelevant)
I installed my CPU the other night, and the board was running for a good two to three minutes until shutting off on its own. Since then, whenever I attempt to power up the board, it will get surge of energy, the CPU fan does a quarter-spin and then stops.
The standby LED on the board is on when plugged in, and that's it. I've tried just about everything: clearing the RTC RAM in CMOS, removing and re-installing the battery, etc.
This is not a RAM issue, because the board's behavior remains the same when no RAM is present. Help would be appreciated! I hope I didn't screw anything up :/