No signal to monitor

Hello, I have a 460 gtx that has been working fine in my computer for about a year. I removed it while replacing my old liquid cooling system (http://www.newegg.com/Product/Product.aspx?Item=N82E16835103029) with a new cooler (http://www.newegg.com/Product/Product.aspx?Item=N82E16835103065)
I replaced the graphics card and when I turned on the computer, everything runs including the graphics card fan. Except my monitor will flash once then say "no signal".
Could it be that I somehow broke the graphics card when it was removed? I cant think of what else it could be
6 answers Last reply
More about signal monitor
  1. Card not properly seated! Power connections loose!
  2. ^+1
    Are you connected to the monitor and is the connector pushed in all the way. It might look like it is connected but not screwed down.
  3. Found the solution. Ended up having to reset CMOS on the motherboard and now everything is fine.
  4. That is good news and the worry is over. Hat's off to ya.
  5. tepotem3 said:
    Found the solution. Ended up having to reset CMOS on the motherboard and now everything is fine.



    Hi, How did you do that if you had no picture etc on the monitor ? , Reply welcom, Best Regards Jimbo.
  6. You have to physically move the jumper on your motherboard to reset BIOS. Just google reset CMOS and you will see how to do it.
Ask a new question

Read More

Graphics Cards Computer Monitors Graphics Product