We have an Ericson W35 that brings in the internet. It is a wireless 3G modem and also a wireless router.
We have that signal going through ethernet cables to 2 other routers (dlink dir-655) with the DHCP turned off so the W35 can serve the IPs to all the computers. This part is working good.
The part I need help with it this:
From 1 of the dlinks above we have an ethernet cable running to another dlink and we can't get it to work. If we turn on the DHCP on that unit off or we can still not connect to internet.
All the wireless SSIDS are the same and the have same password. They are spread out quite a ways over the farm in the different buildings.
I disabled DHCP and each router is given its own 192.168.1.1 or 192.168.1.2 etc and then the modem/router erricson w35 is set to asign ips between 192.168.1.10 and 100. So ip range .1 - .9 are for my routers and other ips for wireless clients.