Sign in with
Sign up | Sign in
Your question

Cutting led wire , disk error insert system diskj

Last response: in Components
Share
August 30, 2012 4:09:26 PM

i was swapping my psu with an older and more powerful psu , but it wasnt a sata so i plugged everything back in the original one, while the case was open i managed to cut some wires that were for the led lights , the comp still starts without the lights but gives me "disk failure , check cables , insert system disk and press enter". could it be the wires? im sure they're just for led lights.
August 30, 2012 4:14:57 PM

check u r hdd sata cable insert properly
August 30, 2012 4:24:43 PM

is your drive been seen in the BIOS? and re check all your connections.
Related resources
August 30, 2012 4:32:41 PM

I would repair the cables I cut and retest.


August 30, 2012 4:55:35 PM

davidgermain said:
is your drive been seen in the BIOS? and re check all your connections.


?
all the cables are plugged in as tight as possible and how would i check if its recgonizing the hdd, it shows which one to boot 1st including hdd, boot agent etc.. so is it being recgonized there?
August 30, 2012 5:01:07 PM

i have tried swapping the psu and changed the sata cables , and still get the error message, and doesnt seem to be recgonizing HDD in bios
!