Thermaletake Overseer RX1 Logo led light not working

Could be that you haven't plugged the led connectors into the motherboard properly, are you sure the live and ground pins match up to the live and ground on the motherboard.

did you connect the 4 pin molex that powers the logo?

http://www.overclockerstech.com/thermaltake-overseer-rx...

right at the bottom of the linked page

hmm this might be it , this is my 2nd case that i have built so i don't have that much experience. But thank you for your tips will try this.
Also one more question are you talking about the LED pw H.D.D power cables etc?

or does that light maybe have a specially separate cable/wire ?

Cause i can't see a wire routing from it

hmm intresting , don't think so. will double check

As far as for the rest i have connected all the images in your link at the bottom of the page

noob question : where do i connect the 4 pin molex?

Refer to your motherboard manual as some have the pins in different configurations.

to a molex connector from the psu

i should have pointed out that the logo isnt the power on button--thats seperate from the logo

so thats why its not likely to be LED pw H.D.D power cables etc problem--if it powers up ok

quite normal for thermaltake to have a molex which may even run through an inverter to power logo

had a thermaltake xaser case years ago that did it that way

Already good news , was able to finally get it working. Thanks for the info guys!