i posted a thread a few days back with my Build ( Asrock z77 Extreme/i5 3570k/G.Skill 8bg/ Corsair TX650v2)
first day i had problems bringing up a Post Screen *which was resolved. Loaded up til the board loaded/listed a few parts and brought up the Press f2 to Bios/f1 to continue.
anyway after that i thought i was in the clear to add everything w/ the Case. Installed everything to the case, only connected my v12 8 pin/24pin to the board & my PCI-E cables to the Graphics card (GTX 480 6 + 8 Pin) HDMI to Onboard HDMI.
First load we had the black screen, let 10 seconds go by, Debug Code flashed/went thru a few numbers none of which stuck, the code i remember seeing was D7 and i think a7 *looks the same so i couldn't tell or remember* .
Thought to myself hell no not again... Unplugged/checked everything/Used HDMI mini adapter w/ HDMI cable, connected HDMI to Graphics card/ pressed board start.
That Time the screen started off black, 5 Seconds in, the Post screen Flashed but not in a Good way (or i Think) as it flashed as a red/Black post screen. i panicked turned it off thinking wdf. i remember the same codes from the first load popping up/stickin for a bit
Tried again a min later, same thing but i added a USB keyboard. Let it load, same color flash/black screen crap all over again, but i pressed F2 to move into BIOS. Screen did the same black but i could recognize that the page/screen it was on wasn't the same (looked like a BIOS) Debug ran through A2 during loads- a6 when i waited a bit.
anyway i need help/ideas on troubleshooting the Black/Red -> Blank -> Black/Red ->Blank Screens
*we will resume build on friday so that i can find out what the problem might be*..... let me know if more information is needed, i was rather frustrated looking thru old posts on these forums w/ not a whole lot of them being resolved (Especially frustrated that my old post didn't have any post but had Views which was somewhat resolved using the troubleshooting guide in the Sticky topic.).