Sign in with
Sign up | Sign in
Your question

24 pin connector

Last response: in Components
Share
January 7, 2013 5:09:13 PM

Hello;

I have a power supply that I want to change it's 24 pin connector. Is it ok if i cut the wires at the end of the original 24 pin of the psu, then bring any 24 pin with it's wires and connect them?
Please check image below(I mean cutting the wires with 24 pin, and then connecting the new 24pin with it's wires to the wires of psu).

http://www.use.com/b3ca3c66b997eb2bf8e1

More about : pin connector

a b ) Power supply
January 7, 2013 7:29:28 PM

What's wrong with the 24-pin connector on your power supply just now?
m
0
l
January 7, 2013 8:00:00 PM

pauls3743 said:
What's wrong with the 24-pin connector on your power supply just now?

hi pauls;

the wires are getting out of the connector becuse for 12v + 5v + 3.3v (corsair hx850w silver), there are two wires connected to each of those pins, one wire is coming out from the pin and another stays in, so i decided to bring new 24 pin with it's wires, cut the original 24 pin from psu, and reconnect to the new 24 pin.

is it ok?
m
0
l
Related resources
a b ) Power supply
January 7, 2013 8:21:16 PM

If you know what your doing, I'm Sure it is. But that's a big IF.
m
0
l
a b ) Power supply
January 7, 2013 9:08:56 PM

Pull the pin that sliding out on its own out and then bend the locking tab thats on the pin end of that cable out a little bit and stick it back into the connector until it locks in. Then you'll be good to go.
m
0
l
!