Dont have atx 12v 2x4

[flysky1000]

Hello,
i just bought a new motherboard. i have a 520w powe. and on MB i need ATX 12V 2X4 cable (8pin) but from my power pack there are only one ATX 12V (4pin)

thanks alot.

 

[Motopsychojdn]

It will fit into one half of the 8pin socket, and will power your system fine, the plug is formfit so you cannot plug it onto the wrong half,
the only drawback you may encounter realistically is that overclocking is limited
Moto

 

[flysky1000]

It will fit into one half of the 8pin socket, and will power your system fine, the plug is formfit so you cannot plug it onto the wrong half,
the only drawback you may encounter realistically is that overclocking is limited
Moto

ok. sorry about my next question but im just new in computerbuilding and i never had such a problem

in my manual is written
1. GND (only for 2x4-pin 12V)
2. GND (only for 2x4-pin 12V)
3. GND
4. GND
5. +12V (only for 2x4-pin 12V)
6. +12V (only for 2x4-pin 12V)
7. +12V
8. +12V

so where should i put my atx 12v? i cant put them in 1. 2. 5. 6. or in 3. 4. 7. 8.

 

[Motopsychojdn]

Picture of Mobo socket please? normally it goes in the lower four of the eight,
Also check through section four here if you are new to the gaame, very handy
http://www.tomshardware.co.uk/forum/288241-13-read-posting-buyer-guides-troubleshooting
Moto

 

[flysky1000]

Picture of Mobo socket please? normally it goes in the lower four of the eight,
Also check through section four here if you are new to the gaame, very handy
http://www.tomshardware.co.uk/forum/288241-13-read-posting-buyer-guides-troubleshooting
Moto

my MB - Gigabyte z68xp-ud3 :

http://www.google.lv/imgres?q=gigabyte+z68xp-ud3&um=1&hl=lv&biw=1680&bih=946&tbs=isz:l&tbm=isch&tbnid=RUivhOLgXGxVQM:&imgrefurl=http://www.pixmania.com/es/es/10504926/art/gigabyte/ga-z68xp-ud3-socket-1155.html&imgurl=http://brain.pan.e-merchant.com/9/7/11098679/u_11098679.jpg&w=1000&h=887&ei=ryw9UIXAEfDa4QStt4CoDA&zoom=1&iact=hc&vpx=1342&vpy=168&dur=3746&hovh=211&hovw=238&tx=175&ty=116&sig=118178199610094501236&page=1&tbnh=121&tbnw=137&start=0&ndsp=43&ved=1t:429,r:7,s:0,i:91

 

[Motopsychojdn]

Ok, as that picture is oriented, its the four pins on the lefthand side, nearest the Pcie slot,
make sure the plug is the correct way round and that it is the correct plug,
Step seven here should give you a good visual guide
Moto