Hello, I am using a NXZT Gamma for my first build. I am pretty much finished, however, cable management has been a pain mainly due to the 20-pin PSU-MOBO Connector. I have routed it behind my motherboard tray, along with my other cables. I've made several attempts at sliding the panel back over the case, successfully, however I always end up with a slight half-inch bulge to the bottom right of the panel. I'm able to screw it in but I'm a little worried about the panel not being secured all the way. I've tried several configurations with little change and I believe I have it as best as I can get it. Does the bulge warrant any stress or worry? Or is it mainly an aesthetic problem that I can just brush off?
Thank you in advance for any answers.