Wiring ATA100 into RAID0?

[Guest]

Going to get a couple of 20MB IBM ATA100 HD to do a RAID0 setup. Do I need the ATA100 ribbon cable to make 100% speed or can I use the stock ATA66 ribbon? Also, do I plug both HD into the same ribbon or use a seperate ribbon for each HD? Thanx.

 

[Lars_Coleman]

You would probably want to set the two hard drives as Master's on their own ribbon cables.

The 66 cable is usually the same as the 100. It's usually a 40pin 80wire Ultra cable. The way you can tell them apart is that it will have a blue, grey, and black connector on it.

<font color=red>1GHz AMD x MSI K7T-Turbo x 512MB PC133 x 2-Maxtor 30GB/RAID 0 = Stream Line Butterfly</font color=red>