I hope I picked the right section for a question for a KVM Switch.
I have a Zonet KVM 3016. I turned on my server setup this morning and the kvm did not. After a bit of fooling around I've determined that ports 1 through 4 can't be selected for use. I was able to put the main server through port 9 (which is directly above 1) and do an autoscan. While it cycled through the ports, I put the cables back into port 1. When it got to that one it displayed the image perfectly and moved on to the next. However, I still can't select port 1
My question comes down to what the deuce is going on with my ports? On the bright side of the light bulb, I only need 2 of the 16 ports so I still have some wiggle room