2wire at&t router/modem login

For years, I looked at my home network by using http:\\ address in the browser. Now an AT&T screen says that's an error. I run ipconfig/all and get the router address,, but when I use that At&T also returns an error. This affects all machines in my house, Windows and Mac OSX. Is there a new syntax?
4 answers Last reply Best Answer
More about 2wire router modem login
  1. Best answer
    Shouldn't be... the IP address should always work. Might just need to pull the power on the router and plug it back in. Sometimes I am not able to log into my D-Link router until I power cycle it. Perhaps you need to do the same.
  2. thank you. unplugging it for 30 seconds worked! now I get the same system view through and through the numerical ipadress.
  3. You're welcome!
  4. Best answer selected by johnslaw.
Ask a new question

Read More

Routers At&T Networking