DSR922 and C-band

Forum Home Cinema Equipment : 4DTV Satellite - DSR922 and C-band

Tom's Hardware: Over 1.4 million members in 6 different countries available to answer all your high-tech questions. Sign up now! Its free!
Word :    Username :           
 

Archived from groups: alt.video.satellite.4dtv (More info?)

 

Probably just a simple question, but I'm quite new at this stuff.
What is the relationship between say for example a sat at 123 degrees
west and the 4 digit dish position number (ie:4850) that comes up when
adjusting the position of your dish.

Sponsored Links
Register or log in to remove.
- 0 +

Archived from groups: alt.video.satellite.4dtv (More info?)

 

On Fri, 13 May 2005 13:34:19 GMT, joe@email.com wrote:

>Probably just a simple question, but I'm quite new at this stuff.
>What is the relationship between say for example a sat at 123 degrees
>west and the 4 digit dish position number (ie:4850) that comes up when
>adjusting the position of your dish.

Nothing really. The numbers on the sat rec. and the positioning of the
sat. are totally unrelated. The numbers on the reciever basically are
for the reciever to "remember" where to go back to, to get to that
sat.

Inside of your actuator arm is a reed switch that is sending "pulses"
to reciever as the actuator extends or retracts. These are the numbers
you see on the reciever pulses.

Rick

Reply to Rick

Archived from groups: alt.video.satellite.4dtv (More info?)

 

The dish positioning numerical values in relation to satellite positions
in the sky are peculiar to JUST THE RECEIVER that is displaying it.For
instance,on YOUR receiver,the satellite position of 123° W longitude
may be associated with dish pulse count position 4580,but on my model
920 4DTV it is at 5040.In fact,with the exception of the 3 most Eastern
satellites,all my pulse count ranges are in the 5000's.I also have my
LNB's installed at a 90° offset rotated setting vs. standard.There are
a lot of variables to this,including siting at installation,where the
original limit set points were when you pulled it out of the box,and
what type of mount you have and how fast it goes through the count
range......my horizon-to-horizon mount will be different than one that
has a telescoping armature.There are a lot of other things too.
In short,no two systems are likely to be identical that way.

Reply to Anonymous
- 0 +

Archived from groups: alt.video.satellite.4dtv (More info?)

 

Thanks, that helps alot. So then I would assume that once you find a
certain sat. you can use this as a base and adjust all the other ones
accoringly and to find for example, G1, you'll know that its the
correct sat. from the channels?

On Fri, 13 May 2005 13:34:19 GMT, joe@email.com wrote:

>Probably just a simple question, but I'm quite new at this stuff.
>What is the relationship between say for example a sat at 123 degrees
>west and the 4 digit dish position number (ie:4850) that comes up when
>adjusting the position of your dish.

Reply to Joe

Archived from groups: alt.video.satellite.4dtv (More info?)

 

joe@email.com wrote:
> Thanks, that helps alot. So then I would assume that once you find a
> certain sat. you can use this as a base and adjust all the other ones
> accoringly and to find for example, G1, you'll know that its the
> correct sat. from the channels?
>
> On Fri, 13 May 2005 13:34:19 GMT, joe@email.com wrote:
>
>
>>Probably just a simple question, but I'm quite new at this stuff.
>>What is the relationship between say for example a sat at 123 degrees
>>west and the 4 digit dish position number (ie:4850) that comes up when
>>adjusting the position of your dish.
>
>
Right, you are. Once you get one sat programmed the next one is
usually 10 to 20 clicks, (on your remote), away. On the 922 the
programming window will even tell you to "move dish to...." This is an
approximation of the next location. Remember use an ACTIVE channel to
fine tune.

Reply to Anonymous
- 0 +

Archived from groups: alt.video.satellite.4dtv (More info?)

 

Ok, my real problem is that I can not get the guide to come up. I've
called a provider and have had a few hits. My time is good but no
guide. The signal/quality is about 66/99 an G1-3. In the system status
screen the authoriztion status changes from us to zk to oc, depending
on the channel. The diagnostics screen C (?) always says us/us. The
provider tried doing the hit on a few different channels but I still
have no guide. Done the soft reboot a few times as well. I do get
CSPAN and the shopping network etc... and a bunch of screens that come
up with "need supscription" so I assume the receiver is working fine.
Any ideas would be greatly appreciated.

On Sun, 15 May 2005 06:40:32 -0700, Ed Mc <namvtn@whatdayaknow.com>
wrote:

>joe@email.com wrote:
>> Thanks, that helps alot. So then I would assume that once you find a
>> certain sat. you can use this as a base and adjust all the other ones
>> accoringly and to find for example, G1, you'll know that its the
>> correct sat. from the channels?
>>
>> On Fri, 13 May 2005 13:34:19 GMT, joe@email.com wrote:
>>
>>
>>>Probably just a simple question, but I'm quite new at this stuff.
>>>What is the relationship between say for example a sat at 123 degrees
>>>west and the 4 digit dish position number (ie:4850) that comes up when
>>>adjusting the position of your dish.
>>
>>
> Right, you are. Once you get one sat programmed the next one is
>usually 10 to 20 clicks, (on your remote), away. On the 922 the
>programming window will even tell you to "move dish to...." This is an
>approximation of the next location. Remember use an ACTIVE channel to
>fine tune.

Reply to Joe

Archived from groups: alt.video.satellite.4dtv (More info?)

 

joe@email.com wrote:
> Ok, my real problem is that I can not get the guide to come up. I've
> called a provider and have had a few hits. My time is good but no
> guide. The signal/quality is about 66/99 an G1-3. In the system status
> screen the authoriztion status changes from us to zk to oc, depending
> on the channel. The diagnostics screen C (?) always says us/us. The
> provider tried doing the hit on a few different channels but I still
> have no guide. Done the soft reboot a few times as well. I do get
> CSPAN and the shopping network etc... and a bunch of screens that come
> up with "need supscription" so I assume the receiver is working fine.
> Any ideas would be greatly appreciated.
>
>

I've had similar problems, and I had kinda' resigned myself to not
having the guide. But about a week ago I re-peaked my dish position and
skew and started getting the guide, at least part of the time. It
doesn't download on demand, but does seem to download overnight when it
works.

I'm using a 6.5' dish and have attributed my difficulties to that.

Take care,
Rich

God bless the USA

--
With all of our running and all of our cunning
If we couldn't laugh we would all go insane.

Jimmy Buffett

Reply to Anonymous
- 0 +

Archived from groups: alt.video.satellite.4dtv (More info?)

 

You gotta love Jimmy Buffet. Tried leaving it overnight, and no go

On Mon, 16 May 2005 21:11:05 -0500, Rich Piehl
<rpiehl5REMOVETHIS@FORNOSPAMcharter.net> wrote:

>joe@email.com wrote:
>> Ok, my real problem is that I can not get the guide to come up. I've
>> called a provider and have had a few hits. My time is good but no
>> guide. The signal/quality is about 66/99 an G1-3. In the system status
>> screen the authoriztion status changes from us to zk to oc, depending
>> on the channel. The diagnostics screen C (?) always says us/us. The
>> provider tried doing the hit on a few different channels but I still
>> have no guide. Done the soft reboot a few times as well. I do get
>> CSPAN and the shopping network etc... and a bunch of screens that come
>> up with "need supscription" so I assume the receiver is working fine.
>> Any ideas would be greatly appreciated.
>>
>>
>
>I've had similar problems, and I had kinda' resigned myself to not
>having the guide. But about a week ago I re-peaked my dish position and
>skew and started getting the guide, at least part of the time. It
>doesn't download on demand, but does seem to download overnight when it
>works.
>
>I'm using a 6.5' dish and have attributed my difficulties to that.
>
>Take care,
>Rich
>
>God bless the USA

Reply to Joe
Tom's Hardware > Forum > Home Cinema Equipment > 4DTV Satellite > DSR922 and C-band
Go to:

There are 460 identified and unidentified users. To see the list of identified users, Click here.

Please mind

You are about to answer a thread that has been inactive for more than 6 months.
If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.

Add a reply Cancel
Sponsored links
  • Ask the community now
  • Publish
Ad
They won a badge
Join us in greeting them
  • 13:08 OvrClkr won the Overclocking badge
  • 01:00 vianescute won the Freshman badge
  • 01:00 meywd won the Freshman badge
  • 01:00 nayega won the Freshman badge
  • 01:00 gpfear won the Freshman badge
  • 01:00 Conrad925 won the Freshman badge
  • 01:00 skythra won the Freshman badge
  • 01:00 Ckaz won the Freshman badge
  • 01:00 james59 won the Uniformed badge
  • 01:00 snarl won the Uniformed badge