How to hookup netgear 614 router to netgear 3300 access point

[wjesse]

I tried to use my Netgear 614 router to my Netgear 3300 as an access point to gain range. But now I think I've screwed up the IP address(s) and have lost my wifi ability. How do I fix all this? HELP

 

[Emerald]

http://www.tomshardware.com/forum/36406-43-convert-wireless-router-wireless-access-point

 

[wjesse]

http://www.tomshardware.com/forum/36406-43-convert-wireless-router-wireless-access-point

Perhaps that what I screwed up.I did as you said, and two sections came up:
Tunnel adapter 6to4,....... and with that one he default gateway was
2002:C058:6301::C058:6301

The second section:
Tunnel Adapter Automic....
The default gateway was blank. In neither case was there anything like 192.168.0.1. But it seems to me that before I screwed it all up, there was a 192.168.1.1, and the second part of that was 255.255.255.0

I've made a mess of it all. Would dynamite help?

 

[Emerald]

reset that router to manufacturer default

 

[wjesse]

reset that router to manufacturer default

It took me a while to find the button....OK... the default gateway is 192.168.1.1

 

[wjesse]

OK, I've got my router (Netgear 614 ver 9) back up and running now. now what?

 

[Emerald]

http://www.tomshardware.com/forum/36406-43-convert-wireless-router-wireless-access-point

 

[wjesse]

No, it's not fixed yet. I did as you said:
"Now connect the router to be converted only to a computer via network cable and log in

Setup the wireless security "

...but found no place to log-in or do anything. In a bad attempt to try to make my ignorance less obvious. I fished around until I lost my wifi altogether (in spite of what the computer says).